Door Repair Hamilton

Door Repair Near Me repairs, installs and replaces doors across Hamilton — the century brick homes below the escarpment, the post-war housing on the Mountain, and the commercial and industrial units through the north end and along Barton. Bonded, insured, police background-checked. Call (647) 955-5637 for a free estimate.

Hamilton’s Housing and What It Does to Doors

Hamilton has one of the older housing stocks in the region, and that shapes the work:

• Century and pre-war brick homes (Durand, Kirkendall, Stipeley, Crown Point). Original solid wood doors in original frames, often on masonry openings. These are worth saving — the usual failure is rot at the jamb bottom and a frame that has shifted, not a failed door. See wood door repair.
• Masonry openings behave differently. On brick, a settled or shifted frame cannot simply be repacked the way it can in a wood-framed wall — resquaring has to work with the opening. This is the single biggest reason a Hamilton door “keeps sticking after it was fixed”.
• Mountain post-war housing. Aging steel entry doors and 1970s-90s patio doors with flattened rollers and worn tracks — see sliding and patio door repair.
• Escarpment exposure. Properties on the brow and upper Mountain take considerably more wind, which is hard on closers, seals and anything that has to latch against pressure.

Door Services in Hamilton

• Residential door repair — entry, interior, patio and sliding
• Door frame and jamb repair, including masonry openings
• Door replacement and installation
• Commercial and industrial door repair
• Storefront door repair on Barton, King, James and Ottawa Street
• Emergency door repair in Hamilton and board-up
• Aluminum and glass door repair, glass door replacement
• Exterior door frame repair and wood door repair in Hamilton
• Locks, rekeying and deadbolts

Areas of Hamilton We Cover

Downtown, Durand, Kirkendall, Strathcona, Corktown, Stinson, North End, Crown Point, Gibson, Landsdale, Westdale, Ainslie Wood, the central and west Mountain, Ancaster, Dundas, Stoney Creek and Waterdown.

Commercial and Industrial Door Work

Hamilton’s commercial work divides between the retail strips and the industrial north end. On Barton, King, James North and Ottawa Street the recurring job is aluminum storefront doors that have dropped on a worn pivot and started dragging — an early fix keeps it from becoming a corner rebuild. In the industrial areas the work is heavier: hollow metal doors and frames with base corrosion, panic hardware, and closers on doors that cycle constantly. Where a frame has rusted through or a fire rating has been compromised, we handle full assembly replacement.

Front Door Replacement in Hamilton

Most front doors we replace in Hamilton were not worn out by age alone. They failed because water got into them. A wood slab on a Kirkendall or Crown Point porch soaks up moisture at the bottom edge, swells every winter, and eventually splits at the lower rail. A builder-grade steel door on a 1980s Mountain home rusts from the bottom up because the sweep wore out and nobody replaced it. Once the skin is rusted through or the core has delaminated, painting and re-weatherstripping will not bring it back.

Repair or Replace: How We Decide

We look at three things before recommending a new door. First, the slab: is it solid, flat and free of rot or rust-through? Second, the frame: is the sill sound, are the jambs solid at the bottom, and is the opening still square? Third, the energy picture: can you feel cold air around the door even with new weatherstripping? If only one of those is a problem, a repair is usually far cheaper than replacement. If two or three are failing, a new pre-hung unit with its own frame and sill is the better spend.

What a Hamilton Entry Door Replacement Involves

• A free in-home measurement of the rough opening, not just the old slab, so the new unit fits without shimming tricks.
• Removing the old door and frame and checking the subfloor and framing underneath for rot.
• Setting the new pre-hung unit plumb and level, insulating the gap with low-expansion foam, and flashing the sill so water drains out instead of in.
• Fitting the lockset and deadbolt so the bolt throws fully into a reinforced strike, then adjusting the weatherstripping so the door closes with light pressure.

Our published starting prices apply here too: a front entry door from $999, a steel entrance door with glass insert from $1,199, and a fiberglass door with glass insert and design from $1,499. Older homes with non-standard openings sometimes need a custom-sized unit, and we will tell you that at the measurement stage, not on installation day. For a closer look at frame work alone, see our exterior door frame repair in Hamilton page.

Hollow Metal Door and Frame Replacement

Hamilton still has a lot of working industry, from the plants along the bayfront to the business parks in Stoney Creek and on the Mountain. Those buildings run on hollow metal doors: steel slabs in welded or knock-down steel frames, usually with closers, panic hardware and heavy hinges. They take far more abuse than any house door, from forklifts, pallet jacks, wind loads on loading dock sides and hundreds of cycles a day.

When a Hollow Metal Door Can Be Saved

A hollow metal door that drags or will not latch is often a hinge or frame problem rather than a door problem. Worn hinge knuckles let the slab drop, and the leading edge starts hitting the strike jamb. Replacing the hinges, re-securing the frame anchors and adjusting the closer often puts the door back in service the same day. Dented skins that still close and latch properly can usually stay.

When the Door and Frame Need to Go

Replacement makes sense when the bottom of the frame has rusted away from salt and standing water, when the slab is bent so badly it no longer sits flat in the stop, or when the frame has been pushed out of the wall by an impact. In those cases we remove the old frame, check the masonry or stud opening, set a new frame plumb and anchored, and hang a new slab prepared for your existing hardware where possible. If the opening is a rated exit or fire separation, tell us at the estimate so the replacement assembly matches what the building needs.

We also handle aluminum and glass entrances on commercial frontages. If a storefront or lobby glass panel is the issue rather than the steel door, our Hamilton glass door replacement team covers that work.

Door and Hardware Maintenance for Hamilton Property Managers

Most commercial door calls we get are failures that a short visit a few months earlier would have caught. A closer leaking oil, a hinge screw backing out, a strike plate worn into a groove. Left alone, each of these turns into a door that will not lock at closing time, which is when it becomes an emergency call instead of a maintenance item.

What a Scheduled Door Check Covers

• Closers: checking for oil leaks, setting closing and latching speed so the door shuts fully without slamming, and tightening the arm and mounting screws.
• Hinges and pivots: looking for worn knuckles, loose screws and sag, and replacing hinges before the door starts rubbing the frame.
• Locks and exit devices: confirming deadbolts throw fully, panic bars release with normal hand pressure, and strikes are not worn or loose.
• Weatherstripping and sweeps: replacing torn seals on exterior doors before winter, especially on doors facing the lake wind.
• Frames: checking anchors, rust at the base, and any gaps that point to the frame moving in the wall.

Who This Suits

Plaza owners, apartment building managers, condo boards and industrial tenants with many doors get the most from a scheduled check. You get a list of what needs work now and what can wait, so repairs are planned rather than urgent. Call (647) 955-5637 to set up a walkthrough.

Door Installation in Hamilton

Installation is not only for new builds. We install interior doors during renovations, steel side and garage-entry doors, patio and sliding doors, and commercial doors in tenant fit-outs across the city, from Waterdown down to Binbrook. The work is the same principle every time: the frame decides how well the door works. A slab hung in a twisted opening will bind, leak air and wear out its hinges early no matter how good the door itself is.

Installation Details That Matter

On older Hamilton houses, the floors and walls have often settled, so openings are rarely square. We check diagonals before ordering, shim the jambs where they need it rather than forcing the frame, and set the hinge side first so the latch side lines up. For basement and side entries, we pay extra attention to the sill, because that is where water collects. Full details of the service are on our door installation in Hamilton page.

If a door has been forced or damaged and you cannot lock up, that is a different job. Our Hamilton emergency door repair service can secure the opening first, and a proper replacement can follow once the immediate risk is dealt with.

Need a front door replaced, a steel frame swapped or a building’s doors checked in Hamilton? Call (647) 955-5637 for a free estimate.

Frequently Asked Questions

My century home’s front door sticks every summer. Should it be planed?

Often not. Seasonal sticking on an older solid door is usually an unsealed top or bottom edge taking on moisture. Sealing all six surfaces frequently solves it without leaving winter gaps.

Can an original heritage door be saved?

Usually yes. Older solid doors are very repairable — rotted sections can be spliced with matched timber and hardware areas reinforced.

Do you work on Hamilton’s industrial and warehouse doors?

Yes — hollow metal doors and frames, closers, panic hardware and base corrosion repair.

Do you cover Dundas, Ancaster and Stoney Creek?

Yes, along with Waterdown and the surrounding area.

How long does a front door replacement in Hamilton take?

Once the door is ordered and on site, most standard pre-hung entry doors are installed in a single visit. The longer part is usually ordering, especially for custom sizes, glass inserts or fiberglass doors with a design. We give you the expected timeline at the free measurement.

Can you replace just a hollow metal frame and keep the existing door?

Sometimes. If the slab is straight and in good shape, it can be rehung in a new frame as long as the hinge and lock preparations line up. If the slab is bent or rusted, replacing the door and frame together is normally the cheaper option over the long run.

Do you offer ongoing door and hardware maintenance for commercial buildings?

Yes. We can visit on a schedule that suits the building, check closers, hinges, locks, exit devices, weatherstripping and frames, and give you a list of what needs attention. Call (647) 955-5637 to arrange a first walkthrough.

Is it worth repairing an old steel front door instead of replacing it?

If the steel skin is not rusted through and the door is still flat, new weatherstripping, a new sweep, adjusted hinges and a realigned strike can make it work well again. If the bottom edge is rusted out or the door is warped, replacement is the better choice.

Book a Door Repair in Hamilton

Send a photo of the door and the jamb bottom and we can usually tell you what you are dealing with before attending. Call (647) 955-5637 or use our contact form.