Toronto Door Replacement

A front door is only as good as the frame it hangs in. When the jamb is split, rotted or pushed out of square, the door sticks, leaks, drafts and stops locking properly, and no new weatherstrip or lock will fix it. This guide explains when an entry door frame can be repaired, when it needs to be replaced, what the replacement involves and how to avoid surprises. If you need help now, call 647-955-5637 or see our door frame replacement in Toronto page.

22+years in the door trade
✓Bonded & insured
✓Police-checked technicians
$0Free estimates
Entry door frame repair in Toronto
Entry door frame repair in Toronto

Signs your entry door frame needs attention

  • Soft or crumbling wood at the bottom of the jamb or the sill
  • Cracks running up and down from the strike plate after a break-in
  • Hinge screws that spin and will not tighten
  • A door that sticks even after the hinges are adjusted
  • Gaps between the frame and the wall, or water stains on the floor inside
  • Rust along the bottom of a steel frame

Repair or replace the frame?

When repair is enough

Local damage can usually be repaired. A jamb split behind the strike after a kick-in is glued, reinforced and re-screwed into the framing. A small rotted section at the bottom of a jamb can be cut out and replaced with new wood, then primed, painted and sealed. Stripped hinge screw holes are filled and the hinges anchored with long screws.

When replacement is the better fix

Replacement makes sense when rot runs up the jamb, the sill is rotted through, the frame is badly out of square, or several parts are failing at once. In those cases a new frame, often supplied with a new door as a pre-hung unit, gives a straight, sealed opening that will last.

Door stuck, broken or forced?

Talk to a door technician now. Free estimates across Toronto and the GTA.

Front door and frame replacement
Front door and frame replacement

Frame only, or door and frame together?

If your door slab is in good condition, a new frame can sometimes be built to fit it, but the door must be checked carefully for warping and fit. In most homes, when the frame is replaced, a pre-hung door is installed: the door already hung in its own new frame, with hinges, bore holes and weatherstripping. It is usually faster and produces a better seal than rebuilding an old frame around an old door.

What an entry door frame replacement involves

1. Measuring the rough opening

The technician measures the opening and checks it for level, plumb and square so the new frame fits without forcing.

2. Removing the old frame

Interior and exterior trim is removed carefully, the old frame is cut free, and the sill area is inspected for hidden rot in the subfloor.

3. Setting and shimming the new frame

The new frame or pre-hung unit is set on a sealed sill, shimmed at the hinge and lock points, and fastened into the wall framing.

4. Insulating and sealing

The gap around the frame is insulated, exterior joints are caulked and flashing is checked so water cannot get behind the frame again.

5. Hardware and testing

The lock and deadbolt are installed or transferred, the strike is reinforced, and the door is tested for smooth closing, sealing and locking.

New door frame installed and sealed
New door frame installed and sealed

Cost factors (2026)

Every opening is different, so the price is given after measuring. The main factors are:

  • Whether only the frame is replaced or a full pre-hung door is installed
  • Door material: steel, fibreglass or wood
  • Sidelites, transoms or glass inserts
  • Hidden rot in the sill or subfloor
  • Trim, finishing and painting

Choosing the right frame material

Wood frames

Traditional wood jambs are easy to repair and finish, but the bottom few inches are vulnerable to water. If you choose wood, make sure the end grain at the bottom is sealed and the sill is properly flashed.

Composite and PVC-clad frames

Composite jambs, or wood frames with a rot-resistant bottom section, are popular for replacement because they do not absorb water. They are a good choice for doors exposed to rain and snow, such as unprotected front porches and back doors.

Steel frames

Steel frames are common on back doors, garage entry doors and commercial openings. They are very strong, but the bottom can rust if water sits against it. Rust-through usually means the frame section or the whole frame must be replaced.

Sidelites, transoms and double doors

Entry doors with sidelites or transoms have larger frames with more joints, and each joint is a place where water can get in. When these frames rot, it is often at the bottom corners of the sidelites. Replacement may involve the whole unit so all the parts match and seal properly. Double entry doors need both leaves to line up perfectly; a frame out of square makes the astragal and flush bolts fail.

Sills and thresholds: the hidden problem

The sill takes the most water of any part of the door. A sill that slopes toward the house, a missing drip edge or failed caulking will rot the subfloor underneath, sometimes for years before it shows. During a frame replacement, the sill area is opened and checked, and any soft subfloor is repaired before the new frame goes in. An adjustable threshold lets the door seal tightly as the house moves with the seasons.

Get it fixed properly the first time

Tell us what the door is doing and we will tell you if it needs repair or replacement.

Security upgrades during a frame replacement

A new frame is the perfect time to make the door much harder to force:

  • A heavy-duty strike plate with long screws into the wall framing
  • At least one long screw in every hinge
  • A deadbolt with a full one-inch throw
  • A solid steel or fibreglass door instead of a hollow or damaged one

How to keep a new frame lasting

  • Re-caulk the exterior joints whenever the caulking cracks
  • Keep gutters above the door clear so water does not pour onto the sill
  • Clear snow and ice away from the threshold in winter
  • Touch up paint on wood frames as soon as it starts to peel
  • Check the door sweep and weatherstrip every fall

Winter frame problems in the GTA

Freeze-thaw cycles open small gaps in caulking and push moisture into wood. In January, homeowners notice frost on the inside of the door, drafts along the latch side and doors that suddenly stick. Most of these trace back to the frame. Fixing the frame and seals in the fall prevents the worst of it.

Frame damage after a break-in

Most forced entries split the jamb rather than break the lock. After a break-in, the door is secured the same day, then the jamb is repaired or replaced and reinforced with a heavy-duty strike and long screws. If the frame is badly damaged, replacing it is often the safest choice.

Door frame replacement across the GTA

We replace and repair entry door frames across Toronto and the GTA, including Mississauga, Oakville, Newmarket, Aurora, Ajax, North York, Richmond Hill, Brampton and East York. Related services: door installation in Toronto, sliding door repair and commercial door repair.

Frequently Asked Questions

Can a rotted door frame be repaired instead of replaced?

Yes, if the rot is limited to a small area. The damaged section is cut out, replaced and sealed. If rot runs up the jamb or through the sill, replacement is more reliable.

Do I need a new door if I replace the frame?

Not always, but a pre-hung door and frame together usually gives the best fit and seal.

How long does an entry door frame replacement take?

Most standard entry doors are completed in a single visit once the door or frame is on site.

Can a frame split by a break-in be fixed?

Usually yes. The split jamb is repaired or replaced and reinforced so the door locks securely again.

Why does my door still stick after adjusting the hinges?

The frame is probably out of square or damaged. Re-shimming or replacing the frame solves it.

Do you replace door frames in Toronto?

Yes, across Toronto and the GTA. Call 647-955-5637 to book.

Get it fixed properly the first time

Tell us what the door is doing and we will tell you if it needs repair or replacement.

Leave a Reply